Model LPA-60-10

Custom Quotes Available!

Low Profile Aluminum Conveyor:

Used for lightweight finished part applications. This conveyor is ideally suited for under-the-press application of small to medium sized injection molding machines, general purpose light weight parts. This design can be used in conjuction with MAC's exclusive quick change mounting packages or can be used in aisle based on the floor applications.

Exclusive Series Features:

Frame: Extruded alauminum frame with extruded cross member and stainless slider bed.
Take up Assemblies: Unique and innovative take-up design for tracking adjustments and quick belt changes.
Belt Tensioning: Located at any one of the four corners makes fine tuning changes simple.
Pulleys: Sealed needle bearings.
Frame sizes: 2.312" (standard), and 1.875" (optional).
Motor Starter: Includes rocker switch with thermal overload.
Exterior T-slots: Allow for mounting of additional modular compnents.
Warranty: Two year limited.

Specifications

Lengths available: 2' to 12' lenght increments on 1'lengths
Widths: 2.75" to 20" on 1" increments

Techincal Information:

Frame:	2.312" frame height, extrudes aluminum, with extruded cross member and stainless slider bed plate. Optional frame height of 1.875" - allows belt to be higher as a standard
Side Rails:	None as standard. Frame is .437" taller than belt surface as a standard
Belt:	B2: white, 2 ply P.U. cover with endless finger splice, other urethane belts available
Belt Widths:	2.75" - 20" on 1 inch increments
Length:	2' to 12' on 1 foot increments (standard)
End Drive:	Located at any one of the four corners, dependent upon length and applictionl Positions M3, M4 are preferred, M1. M2 are available if applicable, side mounted drive M7, M8, M5, M6 are also available as an option. Standard drives are 120VAC/1/60 HZ motors
Speeds:	20 FPM (standard), 54 FPM - is at no charge
Pulley:	1" drive and tail pulleys are both machined with trapezoidal crowns, shafts are 5/8" diameter and bearings are sealed self-aligning type, needle bearings
Take-up Assembly:	Allows for 1" of take-up of belt adjustment
Electrical Control:	Manual motor starter with thermal overload protection and 12' of SJ 16/3 cord with plug for (1) 120VAC input power as standard
Supports:	Various extruded leg styles with adjustable heights available - Please inquire

Home I Products I Conveyors I Custom Quotes I Contact Us