|
Horizontal to Decline Aluminum Conveyor with Platform:
The “Horizontal to Decline” belt conveyor series is a profile that is used for light –medium weight, finished part applications. This conveyor is ideally suited for beside the press applications to receive parts from a IMM press mounted robot and transition from one elevation to another for inspection or assembly or packaging. The angle of decline is adjustable from 0-30 degrees for elevation changes. A belt with a sticky grooved top is used to grip parts The fully welded frame construction of this model produces a solid square frame for industrial use.
Standard Features: |
- Welded inner steel frame with a clear anodized exterior frame and side-rails. Aluminum is 6061 extrusion in a T5 condition. Height of frame is 2.625".
- 2.5" tall clear anodized extruded aluminum side-rails.
- 0-45 degree range of angle adjustment.
- Belt edges recessed
- Longitudinal grooved belt, with green, anti-static, PVC top cover, splice is endless
- V-guided belt tracking
- Hold up roller at angle adjustment in a cast aluminum knuckle on return side.
- Nylon belt wear strips on top and return to isolate belt surface from sources of contamination and to reduce gap between side-rail and belt.
- One piece machined trapezoidal crown, steel pulleys 2.125" diameter machined for V-guided belt.
- Sealed, self-aligning bearings in cast aluminum housing
- Bearing ring covers to prevent rotating parts from being exposed.
- Manual motor starter.
- 110/60/1 gear-motor
- 20fpm nominal fixed belt speed.
- 12' long power cord and plug.
- Unit is completely assembled, wired, and tested prior to ship.
- Two-year limited warranty
|
| Techincal Information: |
| Frame: |
3.5
|
| Side Rails: |
2.5” extruded aluminum side rails without top return, overlap is .325” per side |
| Belt: |
B11. Green PVC longitudinal cover, Anti-Static, splice is endless bias angle skive type. |
| Belt Widths: |
6”,12”,18”,24”,30” |
| Length: |
Combined Lengths to a max. of 15’ (2’ min on drive) and (2.5’ min. on take-up end), manufactured in 1’ increments (standard)
|
| End Drive: |
Located at end, M1, M2, M3, M4 are standard M9, M10, M11, M12 are available at no charge. Sive positions M5, M6 are available. Positions M13, M14, M7, M8 are available (please consult factory) Standard drives are 120VAC/1/60 HZ motors.
|
| Speeds: |
22 FPM (standard), 45, 67, 133 FPM - available at a nominal charge |
| Pulley: |
3” drive and tail pulleys are both machined with trapezoidal crowns, shafts are 5/8” diameter and bearings are sealed self-aligning type, no lubrication required. Drive pulley is fully lagged.
|
| Take-up Assembly: |
Allows for 2.5 inches of take-up of belt adjustment |
| Electrical Control: |
NEMA 1 enclosure with push button manual motor starter with thermal overload protection and 12’ of SJ 16/3 cord with plug for 120VAC input power as standard.
|
| Supports: |
Steel telescoping T- supports are provided, please specify the required elevations |
|
|
|
