Small Frame Aluminum Conveyor:
The "Small Frame Aluminum" belt conveyor series is a profile that is used for light weight finished part applications, where cleanliness and appearance are important. This conveyor is ideally suited for under-the-press application of small to medium sized injection molding machines, and general purpose light weight parts. The models superior construction produces a solid square frame for industrial use.
Exclusive Series Features: |
- Frame: Extruded aluminum frame, 6061 aluminum with T5 temper, clear anodized
- Cross Members: Steel cross members for exceptional torsional rigidity
- Casting: Supports bearings and pulleys featuring a Unique take-up design tracking adjustments at the four corners
- Side Rail Overlap: Recessed belt edges - .375" per side
- Pulleys: Feature a machine trapezoidal crown on head and tail, which provides increase tracking signal
- Bearing Assemblies: Set in castings with covers, no exposed rotating parts
- Belt Edge Wear Strips: Wear Strips on top and return sides, less belt damage on convey and belt return side
- Warranty: Two year limited
|
|
| Technical Information: |
| Frame: |
2.63" extruded frame with welded steel tubular cross members, optional steel slider bed for full belt support. |
| Side Rails: |
2.5" extruded aluminum side rails with top return, overlap is .375" per side |
| Belt Widths: |
6", 12", 18", 24", 30", 36" |
| Length: |
3' to 15' on 1foot increments (standard) |
| End Drive: |
Located at any one of the four corners, dependent upon length and application. Positions M3, M4, are preferred, M1, M2, are available if applicable, side mounted drives, M5, M6, M7, M8 are also available as an option. Standard drives are 120VAC/1/60 HZ motors |
| Speeds: |
22 FPM (standard), 9.5, 14.5, 32, FPM - available at no charge |
| Pulley: |
2.125" Drive and tail pulleys are both machines with trapezoidal crowns, shafts are 3/4" diameter and bearings are sealed self-aligning type |
| Take-up Assembly: |
Allows for 2.5 inches of take-up of belt adjustment |
| Electrical Control: |
NEMA 1 enclosure with push button manual motor starter with thermal overload protection and 12' of SJ 16/3 cord with plug for 120VAC power as standard |
| Supports: |
Various telespar type legs extruded construction with adjustable heights available |
|
|
