Horizontal to Incline Aluminum Conveyor:
The "Horizontal to Incline Aluminum" belt conveyor series is a profile that is used for light to medium weight finished part applications, where cleanliness and appearance are important. This conveyor is ideally suited for under the press or beside the press applications to remove parts from under the machine or transition from another conveyor and elevate up to another piece of equipment or discharge for inspection or assembly. The angle of incline is adjustable from 20-60 degrees for elevation change. The models superior construction produces a solid square frame for industrial use.
Exclusive Series Features: |
- Frame: Extruded aluminum frame, 6061 aluminum with T5 temper, clear anodized
- Cross Members: Steel cross members for exceptional torsional rigidity
- Casting: Supports bearings and pulleys featuring a Unique take-up design tracking adjustments at the four corners
- Side Rail Overlap: Recessed belt edges - .75" per side up to 18" widths or less and 1.75" per side on 24" and 30" width
- Pulleys: Feature a machine trapezoidal crown on head and tail, which provides increase tracking signal
- Bearing Assemblies: Set in castings with covers, no exposed rotating parts
- Belt Edge Wear Strips: Wear Strips on top and return sides, less belt damage on convey and belt return side
- Warranty: Two year limited
|
| Technical Information: |
| Frame: |
2.63" extruded frame with welded steel tubular cross members, optional steel slider bed for support across the full width. |
| Side Rails: |
5" extruded aluminum side rails without a top return, overlap is .75" per side or 1.75" per side on 24" and 20" wide models. Belt widths greater than 18" have R16, 3.5" tall stainless side rails. |
| Belt: |
B2: 2 ply, white, FDA approved P.U. cover, Anti-Static with 3/4" cleats welded on 15" centers, splice is endless bias angle skive. Traction side has a VG1 v-guide tracking aid |
| Belt Widths: |
6", 12", 18", 24", 30" |
| Length: |
Combined length of 15' (2' min on drive end) and (2' min on idle end) Manufactured on 1foot increments (standard) |
| End Drive: |
Located at in-feed end, M1, M2, are standard M9, M10. Side mounted drives, M5, M6 are available. Position M3, M4, M7, M8 are available if applicable (Please consult factory). Standard drives are 120VAC/1/60 HZ motors |
| Speeds: |
22 FPM (standard), 9.5, 14.5, 32, FPM - available at no charge |
| Pulley: |
2.125" Drive and tail pulleys are both machines with trapezoidal crowns, with machined V-guided grooves, drive pulley is fully lagged, shafts are 3/4" diameter and bearings are sealed self-aligning type. Drive pulley is lagged with ruff top material |
| Take-up Assembly: |
Allows for 2.5 inches of take-up of belt adjustment |
| Electrical Control: |
NEMA 1 enclosure with push button manual motor starter with thermal overload protection and 12' of SJ 16/3 cord with plug for 120 VAC input power as standard |
| Supports: |
Extruded aluminum telespar type supports. LSA2 series included are CA3 (4" diameter swivel toe locking casters). Elevation at in-feed end is 13.2" - 19.2" adjustable from top of belt to floor with cleats up to 30mm tall. |
|
|
